DAF Upgrade Leads to Sludge Challenges

Dissolved air flotation proved to be an economical and efficient technology fit for treating wastewater with elevated levels of solids or oils in a poultry processing plant

This content is sponsored by JWC Environmental. Sponsored content is authorized by the client and does not necessarily reflect the views of COLE Publishing. View our privacy policy.
DAF Upgrade Leads to Sludge Challenges

Interested in Pumps?

Get Pumps articles, news and videos right in your inbox! Sign up now.

Pumps + Get Alerts

Central America’s largest poultry producer, DIP-CMI, was facing new requirements to meet stricter wastewater discharge regulations with an outdated plant treatment system. The facility, located in San Jose, Costa Rica, processes more than 100,000 birds per day, preparing them for distribution to local markets. Maintaining legal compliance for discharging the effluent into the local waterway was not only important for continuing operations, it was also a fundamental part of the plant’s environmental plan that safeguards the local population the plant serves. 

DIP-CMI reached out to JWC Environmental’s industrial wastewater group for assistance with the design and construction of an upgraded 1.9 million liters per day wastewater treatment facility. The investigation into a viable solution to revamp its existing wastewater treatment infrastructure drove a more comprehensive review of the facility’s end-to-end waste processes, including wastewater sludge management plan and rendering operations.

New limits, new solutions
Common among poultry processing plants, the facility’s wastewater is heavily laden with organic contaminants which contribute to elevated levels of TSS, FOG and COD — all of which are regulated water-quality parameters. The existing DIP-CMI system includes a simple fat trap that performed limited separation of FOG from the wastewater prior to effluent entering a surface aerated lagoon. While the fat trap system was relatively easy to maintain and produced very little waste sludge, it would never have the capability to remove enough solids to stop the overloading of the biological process in the aerated lagoon.

To comply with the new direct discharge permit, the facility was required to meet the following concentration limits: less than 30 mg/L of TSS, less than 10 mg/L of FOG, and less than 100 mg/L of COD. JWC Environmental’s approach to this challenge was designing an FRC dissolved air flotation system that was preceded by a JWC IPEC drum screen for initial solids separation.

As the JWC team reviewed the full process flow the next problem was the effect the DAF float sludge would have on the in-plant rendering process. The existing rendering operations were adequate for handling the offal and poultry feathers from the processing lines but the high moisture content DAF sludge would quickly overwhelm the plant’s systems. Increasing the capacity of the plant’s rendering capabilities was not an option so JWC offered its belt filter press to thoroughly dewater the sludge prior to rendering.

Tight on space
A challenge in this overall plan was the limited space available at the facility to bring in new equipment. Through its successful operations, DIP-CMI had grown its poultry production at the San Jose facility to levels much greater than a plant of its size would typically handle. This constraint carried through to the wastewater system and the allotted space for the new wastewater treatment infrastructure was unusually small for the volume of wastewater that needed to be processed. As such, the design of the equipment, as well as the layout of all the components in the building, needed to be pieced together in as tight a configuration as possible.

For the DAF system, JWC Environmental opted for its FRC PCL-60 plate-pack design to accommodate higher flow rates. These units have taller tanks, rather than longer and wider ones, which means when floor space is limited this design can take advantage of the available vertical space.

The FRC sludge dewatering belt press also employed the same vertical design characteristic — stacking each of the dewatering and pressing zones on top of one another — as opposed to arranging them in a lateral configuration. With these technologies and the help of 3-D modeling, JWC designed a two-story system that fit within the allotted space and contained the process equipment necessary to meet the facility’s water-quality requirements.

Up and running
Once the system was brought on-line the benefits of reviewing the full process came to light.  The IPEC drum screen and FRC DAF systems proved to be extremely efficient in removing solids from the waste stream. While very important for compliance it also produced significant amounts of industrial sludge. The belt press gave the plant the ability to process the waste sludge without making costly upgrades to the rendering cookers. 

The design team was able to find additional savings for the sludge dewatering operations. Due to the cleanliness of the DAF effluent it could be used as the wash water for the belt press. This meant that no potable water was required in this part of the sludge management strategy.

The most important success came in the discharge results. Sampling data from the first six months of operation showed sufficient reduction in TSS, FOG and COD concentrations to safely comply with the new discharge permit limits.

Going forward
Dissolved air flotation is an economical and efficient technology to treat wastewater with elevated levels of solids or oils in poultry processing as well as any animal rendering application. Having a successful wastewater upgrade means looking at more than just the immediate treatment solution. Designers must evaluate a plant’s complete wastewater system and consider options for management of sludge and other waste streams that might be produced.

As DIP-CMI continues to grow in Central America, the wastewater treatment technologies employed at the San Jose facility will be used elsewhere — helping maintain the company’s environmental sustainability goals. The outlook of the food production market in Central and South America is bright, and as other companies continue to expand throughout the region, water-quality regulations will require them to make the same efforts in environmental stewardship.

Author’s Note
Adriaan van der Beek is the president of JWC’s industrial wastewater group and has nearly 30 years of wastewater experience. The JWC industrial wastewater group has designed and built more than 500 industrial wastewater treatment installations in more than 20 countries. Learn more at www.jwce.com.


Comments on this site are submitted by users and are not endorsed by nor do they reflect the views or opinions of COLE Publishing, Inc. Comments are moderated before being posted.