6 Signs You May Have a Failing Headworks Screen

This content is sponsored by Huber Technology. Sponsored content is authorized by the client and does not necessarily reflect the views of COLE Publishing. View our privacy policy.
6 Signs You May Have a Failing Headworks Screen

Interested in Headworks?

Get Headworks articles, news and videos right in your inbox! Sign up now.

Headworks + Get Alerts

Screening is one of the most important steps in the operation of a wastewater treatment pant. A well-screened facility is safer, bettered maintained, and easier to operate than a facility with failing screens. But spotting the need for better screening isn’t always as simple as looking at the equipment. Downstream indicators can do wonders to help diagnose a failing screen, and often these downstream processes will be pain points in your operation that you’ve had to remedy or work around.

The following downstream processes are affected by improper screening treatment, and are also six signs that you have a failing headworks screen:

  • Wear and debris accumulation in the grit system: Without proper screening, debris will accumulate in the grit trap, causing wear on equipment. Check your grit handling equipment regularly for signs of wear and accumulation of debris.
  • Presence of debris in separated grit: A failing headwork’s screen will affect grit quality in terms of volatile solids content in the grit and physical appearance (debris in the dewatered grit). A grit washer, which classifies and washes the grit slurry in lieu of a classifier only, might help to alleviate this problem. (Note: If this issue has been a problem since the installation of the equipment, it’s likely not an issue of the screen failing, but rather bar spacing. Larger bar spacing will almost always allow a higher VOC in the cleaned grit. Moving to a finer screen may eliminate the problem altogether.)
  • Clarifiers: Screenings debris might impair the operation of clarifiers. Some debris may float on the surface, impairing skimming of the surface, while other materials might settle in the bottom, impairing operation of skimmers and pumps.
  • Digester equipment: Digester mixers and heat exchangers could potentially be blocked by accumulated screenings debris, making it necessary to clean digesters and heat exchangers on a frequent basis. If you find yourself needing to clean your digesters on a more regular basis, a failing screen may be an explanation.
  • Pumps: Pumps are generally designed to handle some level of impurity in the water they’re handling, but pumps might become blocked and wear out faster due to screenings debris. This is especially true for grit removal pumps and primary/RAS pumps, which are engineered for certain tolerances in the solids they pass through. If pumps are wearing out faster than specified, there may be a debris issue caused by a failing screen.
  • Dewatering systems: Dewatering systems, especially centrifuges and belt filter presses, are negatively affected by screenings debris in the sludge to be dewatered. Screenings debris in sludge also poses a problem as far as the content of the dewatered cake. In many locations, the presence of plastic makes the creation and land application of biosolids illegal. Additionally, some sludge drying systems require debris in dewatered cake to be limited to a certain size, often smaller than 3/8 inch, to prevent operational problems. If your drying equipment is choking on the sludge you’re trying to pass through it, it may point to a screening issue.

Sometimes however, the issue isn’t a failing screen, but a screen that wasn’t properly sized to begin with. There are many factors to consider when sizing a screen for a treatment facility.

Look for Huber Technology’s next article to learn more about how to appropriately size screens.



Discussion

Comments on this site are submitted by users and are not endorsed by nor do they reflect the views or opinions of COLE Publishing, Inc. Comments are moderated before being posted.